VMware VIEW COMPOSER 2.5 - ARCHITECTURE Instrukcja Użytkownika Pobierz pdf (Strona 34)

EMC Infrastructure for Virtual Desktops Enabled by EMC VNX, VMware vSphere 4.1,

VMware View 4.5, and VMware View Composer 2.5

Enterprise switch configuration

Cabling

In this solution, the ESX server and VNX Data Mover cabling are evenly spread across two line

cards to provide redundancy and load balancing of the network traffic.

Server uplinks

The server uplinks to the switch are configured in a port channel group to increase the

utilization of server network resources and to provide redundancy. The vSwitches are

configured to load balance the network traffic on the originating port ID.

We used the following configuration for one of the server ports in this solution:

switchport

switchport trunk encapsulation dot1q

switchport mode trunk

no ip address

spanning-tree portfast trunk

Data Movers

The network ports for each VNX5700 Data Mover are connected to the Ethernet switch. The

ports are configured with LACP, which provides redundancy in case of a NIC or port failure.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 62 63

Brak uwag

VMware VIEW COMPOSER 2.5 - ARCHITECTURE Instrukcja Użytkownika Strona 34